Snmp Objects Value Persistence; Snmp Objects Value Persistence Cli - Cisco CTS-500 Configuration Manual

Appendix A MIBs, RFCs, and SNMP Trap Messages for the Cisco TelePresence System

SNMP Objects Value Persistence

SNMP objects are reset to pre-saved values when SNMPD is restarted. Supported objects are listed in
Table
in, as described in the
Table A-23 SNMP Objects Value Persistence
Supported Devices and Applications
CTS
—
CTMS and CTS-Man
—

SNMP Objects Value Persistence CLI

The following commands are supported in admin mode:
Command
help utils snmp save
snmp save help
help utils snmp reset
snmp reset help
Remember to save your settings for reboot so that you do not have to load the entire code again.
Tip
OL-21851-01
A-23. Command-line interface (CLI) is used to preserve the pre-set values for the objects listed
"SNMP Objects Value Persistence CLI" section on page
Object Type
•
•
•
•
•
•
•
•
•
•
•
•
•
Description
Saves a set of current SNMP object values. The saved values replace the
object default values when SNMPD is restarted.
Resets SNMP default values. Current SNMP objects value will not be
affected. The default values are used the next time SNMPD is restarted.
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
CTMS/CTS-MAN objects
ciscoEnvMonEnableStatChangeNotif
ctpPeripheralErrorNotifyEnable
ctpSysUserAuthFailNotifyEnable
ctpPeripheralErrorHistTableSize
ctpSysUserAuthFailHistTableSize
ctpcStatNotifyEnable
ctpcMgmtSysConnNotifyEnable
ctpcStatMonitoredTable (all active rows)
ctpcStatEventHistTableSize
clogNotificationsEnabled
clogMaxSeverity
clogHistTableMaxLength
SNMP Objects Value Persistence
A-21.
A-21