Testing Cisco Unified Cm With The Pre-Qualification Assistant - Cisco CTS-500 Configuration Manual

Testing Cisco Unified CM with the Pre-Qualification Assistant

Testing Cisco Unified CM with the Pre-Qualification Assistant
For complete Pre-Qualification Assistant installation and operating instructions, see the Configuring
Note
Cisco Unified Communications Manager for Cisco TelePresence Manager chapter of the
Cisco TelePresence System Manager
Install and run the Pre-qualification Assistant to ensure that your pre-installation set up is performed
correctly. The data you enter into the Tool Test Configuration forms are used to verify connections to the
servers and get data from them in order to configure CTS Manager
Figure 6-1
configuration. The Cisco Unified CM Test Configuration form requires the same data for all three
network environments.
form.
Figure 6-1
Table 6-3
Field Name
Host
Bind Mode
Port
Username
Password
Certificate
1.The Cisco Unified CM Host field in the Cisco TelePresence Manager System
configuration uses only IP addresses in a non-DNS environment. If DNS is
configured and accessible, use either hostname or IP address.
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
6-20
shows the Cisco Unified CM test window that allows you to test the Cisco Unified CM
Table 6-3 describes the fields found in the Cisco Unified CM Test Configuration
The Cisco Unified CM Test Configuration Form
The Cisco Unified CM Test Configuration Form Fields
Chapter 6 Setting Up the Room to Use Cisco TelePresence Manager
administration guide on Cisco.com.
Field Value
Hostname or IP address of Cisco Unified CM
Always set to secure mode.
Always set to port 8443.
Logon account with Cisco Unified CM
Administrative privileges.
Password for Cisco Unified CM Admin account.
Full path name to the Cisco Unified CM security
certificate.
1
OL-21851-01