Configuring Additional Settings
MLPP Information
Leave the following fields unchanged:
•
•
Line X on Device X
Leave all fields unchanged. See the
Multiple Call/Call Waiting Settings on Device X
See the
Forwarded Call Information Display on Device X
Leave the following information unchanged in the Forwarded Call Information Display on Device X
Settings box:
•
•
•
•
Configuring Additional Settings
This section contains information about additional configuration settings:
•
Updating SIP Profile Media Ports
You can create a new SIP profile by setting each device to use designated stop and start media ports
within that SIP profile. To change the Start Media Port and Stop Media Port designations in the
Cisco Unified Administration interface, go to Devices > Device Settings > SIP Profile.
Where to Go Next
Proceed to
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
1-40
Chapter 1
Multilevel precedence
Preemption information
"Multiple Call/Call Waiting Settings on Device X" procedure on page
Caller Name
Caller Number
Redirected Number
Dialed Number
Updating SIP Profile Media Ports, page 1-40
Chapter 2, "Configuring the Cisco Unified IP Phone for MIDlets."
Configuring Cisco Unified Communications Manager for the Cisco TelePresence System
"Line X on Device X" section on page
1-36.
1-37.
OL-21851-01