Cisco CTS-500 Configuration Manual page 119

Chapter 6 Setting Up the Room to Use Cisco TelePresence Manager
To migrate to Exchange 2007 and continue using EWS, follow these steps:
Set up Exchange Server 2007.
Step 1
Step 2 Identify the CAS server to which CTS-Manager will integrate.
Step 3 Shut down CTS-Manager.
Step 4 Migrate the CTS-Manager account mailbox to the 2007 mailbox server.
Note Cisco recommends that you also migrate all Cisco TelePresence room mailboxes to the 2007 mailbox
server.
Step 5 Start CTS-Manager and log in.
Step 6 Go to the Configure > Microsoft Exchange window.
Note The connection to Exchange may be down. This is expected.
Step 7 Click Configure EWS. The MS Exchange Web Services window appears.
Step 8 In the MS Exchange Web Services window, enter the connection parameters identified in
Test Connection and make sure that the test is a success.
Step 9 Click the Apply button and wait for CTS-Manager to sync up the data from all of the Cisco TelePresence
mailboxes. This could take from a few minutes to a few hours depending on the size of your deployment.
Migrating From Exchange Server 2007 to 2010
Support for Exchange 2010 is introduced in release 1.7.0. This upgrade path is only available for
CTS-Manager release 1.7.0 and later releases.
The migration path depends on how CTS-Manager is configured to access Exchange Server 2007.
Exchange Server 2010 discontinued WebDAV access; therefore CTS-Manager must be configured in
EWS mode before the upgrade process.
To convert CTS-Manager from WebDAV to EWS mode:
Step 1 Log in to CTS-Manager.
Step 2 Go to Configure > Microsoft Exchange.
Click the Configure EWS button in the right pane.
Step 3
Migrating from Exchange 2003 to Exchange 2007 or 2010
In Exchange 2003, there is no distinction between "User Mailbox" and "Room Mailbox" types. All
mailboxes are created as a "User Mailbox" in Exchange 2003. When you migrate the Cisco TelePresence
room mailbox accounts from Exchange 2003 to Exchange 2007, you need to convert them into "Room
Mailbox" type, especially if they are to be configured with Auto-Accept enabled.
To migrate from Exchange 2003 to Exchange 2007, follow these steps:
OL-21851-01
Configuring Microsoft Messaging Software for Cisco TelePresence Manager
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
Step 2, click
6-11