Labrie AUTOMIZER Helping Hand Operator's Manual page 45

Locking Out and Tagging Out the Vehicle
For any inspection, repair or general maintenance being done on the vehicle, whether on the road or
at the shop, it is the employer's responsibility to establish a proper lockout/tagout procedure and see
to its application.
To lock out and tag out your A
1.
Park the vehicle on safe level ground and apply the parking brake (see Figure 2-21).
Figure 2-21 Parking brake knob
2.
Make sure that the body is completely unloaded.
3.
Turn OFF the hydraulic pump (see P
4. Turn OFF the engine, remove the key from the ignition, store it in a safe and controlled area
(preferably on yourself), and tape over the ignition switch.
5.
Turn OFF and lock the master switch.
6.
Chock all wheels.
The battery set of the A
I :
MPORTANT
turned off.
Figure 2-22 Master switch
7.
Put an "O
8.
Use safety props to block any system that could move by gravity (open tailgate, raised body, etc.).
9.
Drain all air tanks.
10.
Verify and inspect any security device and/or mechanism to make sure that there is no bypass
and that they are all functional.
Part # 200277 (rev.00.10.2024)
UTOMIZER
is equipped with a master switch (see Figure 2-22) that must be
UTOMIZER
S " tag on the driver's wheel and on the front windshield.
FF ERVICE
vehicle:
S on page 74).
UMP WITCH
Safety 33