Labrie AUTOMIZER Helping Hand Operator's Manual page 120

108 Operating the A
UTOMIZER
3. Close the shut-off valve on the suction line (see Figure 2-24).
4.
Carefully inspect and find the cause of the leak.
5.
Call the maintenance facility and report your findings.
6.
If the leak cannot be repaired on site, have the vehicle towed. The leak must be repaired before
restarting the engine. Otherwise, the pump will run out of oil and be damaged.
7. When it is time to restart the pump after repair, ensure that the shut-off valve on the suction line
is fully open and that there is sufficient oil in the hydraulic tank.
Also:
Should there is a problem when using the arm, the packer or any other hydraulic components, press
the E
MERGENCY
Pressing the red button will stop all hydraulic functions on the vehicle, including the arm joystick. All
E
MERGENCY
module (if unit is equipped with more than one control station).
Pulling out the E
will restore all hydraulic functions.
End-of-the-Day Cleaning and Inspection
Cleanliness is a key part of safety and critical to the proper maintenance of the vehicle.
Daily wiping down of all truck lights, warning lights and safety stickers will make your vehicle more
visible and safer for surrounding pedestrians and drivers.
Daily cleaning is crucial because it will minimize breakdowns and maintenance expenses.
The following procedures are necessary for the vehicle to be well maintained and for the operator to
be safe while cleaning the vehicle.
Before performing any cleaning on the vehicle, always make sure that it is parked on level ground
I :
MPORTANT
and that the parking brake is applied.
Part # 200277 (rev.00.10.2024)
S button (red) on any packer control station, whether inside or outside the cab.
TOP
S buttons are functional no matter what control station is selected on the control
TOP
S button that has been pushed down and pressing the P
MERGENCY TOP
switch
UMP