Labrie AUTOMIZER Helping Hand Operator's Manual page 117

Unloading Emergency Actions (Vehicles w/ Tip-to-Dump Body)
If the truck starts to sink on one side as you unload:
Danger!
Danger!
If the body does not raise:
 Check the multiplex monitor screen (see Figure 3-1 [IFM system] or Figure 3-18 [B&R
system]) for an error/warning message. See Table 1 on page 44 (IFM system) or Table 5 on
page 64 (B&R system) for a solution to that error/warning message, if displayed.
 Ensure the hydraulic system is engaged.
The P
UMP
 Make sure the air pressure is above 70 psi.
 Check all fuses in the console.
 Air suspension needs to be dropped or tag axle needs to be down.
 Contact the maintenance facility if there is no change.
Part # 200277 (rev.00.10.2024)
U
NLOADING EMERGENCY ACTIONS
1.
Stop all movement of the equipment.
2.
Start or continue lowering the body.
3.
If the equipment does not stop sinking, stay inside and protect yourself.
Do not use the safety prop with a loaded body. Never stand under a raised loaded body.
switch on the control panel must be green-lighted.
105
Operating the A
UTOMIZER