Labrie AUTOMIZER Helping Hand Operator's Manual page 121

Cleaning the Crusher Panel
: The crusher panel is an option that can be installed on all A
N
OTE
If the unit is equipped with a crusher panel, proceed with the following cleaning procedure:
1. Lower the crusher panel.
2. Extend the arm sufficiently so that you can open the hopper door.
Warning!
Make sure that no one stands directly in the path of the arm before extending it.
3.
Perform the lockout/tagout procedure (see Locking Out and Tagging Out the Vehicle on page 33).
4.
Open the hopper door.
5.
Clean all accumulated dirt around the crusher panel with the hoe and pressurized water.
During the cleaning process, be careful with the limit switch to prevent misalignment.
6.
Once the cleaning is complete, close the hopper door.
7.
Restart the truck and reengage the pump.
8. Raise the crusher panel.
9. Retract the arm alongside the hopper.
Warning!
Make sure that no one stands directly in the path of the arm before retracting it.
10.
Raise the crusher panel completely.
N : This procedure should be performed before the hopper cleaning procedure (see Cleaning the
OTE
Hopper (for Tip-to-Dump Vehicles) on page 110 or Cleaning the Hopper (for Full-Eject Vehicles)
on page 111).
Part # 200277 (rev.00.10.2024)
Operating the A
vehicles.
UTOMIZER
109
UTOMIZER