Labrie AUTOMIZER Helping Hand Operator's Manual page 13

1
Part # 200277 (rev.00.10.2024)
Introduction
The purpose of this manual is to introduce operators
to the operational procedures for the A
information regarding maintenance procedures, refer
to the maintenance manual delivered with your truck
(stored in the provided Labrie USB key).
N : Safety precautions and operating procedures listed
OTE
in this manual apply to all A
regardless of the lifting arm installed on the vehicle
(R -H ™, H
IGHT AND
arm), the type of waste ejection process (either tip-
to-dump or full eject), the type of body
configuration (either split or non-split), the type of
packer installed (conventional or pendulum) and
the type of chassis on which the body is mounted
(either fuel- or electric-powered chassis).
Pre-Operating Instructions
It is imperative that you have carefully reviewed this
manual prior to operating and/or performing any
maintenance on your new A
Side Loader.
Upon receipt of your new A
complete lubrication of the unit. Mechanisms must be
properly lubricated (see lubrication chart on the right
side of the body for details). Factory lubrication is
adequate for production and transport purposes only.
In addition, the return filter element must be replaced
after 50 hours of use. Refer to the maintenance manual
for instructions.
Warning!
A
UTOMIZER
one person.
Mission Statement
Labrie Environmental Group is dedicated to provide
innovative designs, customized quality equipment and
elite customer service.
UTOMIZER
vehicles,
UTOMIZER
-H ™ or A
ELPING AND LLEY
Automated
UTOMIZER
, perform a
UTOMIZER
units must be operated by only
. For
-H ™
AND