Labrie AUTOMIZER Helping Hand Operator's Manual page 119

6. During the ejection phase, slowly move the vehicle forward to prevent garbage from piling up
under the tailgate.
This is the only time you can move the truck with the tailgate raised. Do it very cautiously and cover
I :
MPORTANT
the shortest distance possible. Always be aware of the overhead clearance.
7.
Once the unloading process is completed, press the yellow push-button on the packer control
station (see Figure 3-41) to retract the packer to its home position.
8. When the packer has reached its home position, press and keep down the T
switch on the control panel (see Figure 3-33) to close the tailgate.
Be sure the waste that piled up behind the truck will not interfere with the descending tailgate.
I :
MPORTANT
9.
Once the tailgate is closed, put the safety pins back in place.
10.
Drive away from the unloading site.
11.
Perform the end-of-the-day inspection (See End-of-the-Day Cleaning and Inspection on page 108).
Cleaning of tailgate seal rubber, locking mechanism and front of packer must be done regularly. At
I :
MPORTANT
the end of the ejection phase, take the time to proceed with this task. But before doing so, always
set the tailgate safety prop first (see Tailgate Safety Prop on page 22).
Warning!
Danger!
N : Before driving your truck on highways to your next destination, be sure to fully retract the
OTE
lifting arm and properly position the grabber for transport (that is parked at its fully down
position). Grabber blades must be completely open.
Emergency Actions
Hydraulic Oil Spill
In the event of a hydraulic spill, do the following:
1. Press the E
2. Turn OFF the truck engine.
Part # 200277 (rev.00.10.2024)
Never move the truck backwards with the tailgate in raised position.
Always use the tailgate safety prop while working under a raised tailgate. The safety prop
should be used even if the tailgate is in fully raised position.
red button on the packer control station (see Figure 3-39).
MERGENCY
Operating the A
UTOMIZER
D
AILGATE OWN
.
107