1
6
5
Removing and installing fairing
46 63
Removing and installing covers
46 63
–
Remove seat.
Removing and installing left and right covers
•
Remove trim of cockpit fairing (3) and disconnect
plug for turn indicator.
•
Slacken front securing screw (4).
•
Remove screws (1) securing the side cover.
•
Remove side cover (6).
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
e
Important:
Make sure that the turn-indicator cable is not
trapped when you install the turn indicators.
X
Tightening torques:
Right/left cover with centre cover to frame ..... 2 Nm
Right/left cover to centre cover ...................... 2 Nm
Right/left cover to cockpit fairing at bottom.... 2 Nm
Trim for cockpit fairing to fairing bracket ........ 2 Nm
2
3
4
Removing and installing centre cover
–
Remove left and right covers.
•
Remove screws (2) securing the centre cover.
•
Lift off the centre cover (5).
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torques:
Centre cover to main frame at front ................ 2 Nm
E460044
46.5