Removing and installing starter
motor
e
Caution:
Disconnect earth (ground) lead from battery.
Insulate earth (ground) lead.
•
Remove screw (1) securing starter motor cover.
•
Remove the cover.
•
Disconnect leads (2).
•
Remove screws (3) securing starter motor.
•
Remove the starter motor.
•
Installation is the reverse of the removal proce-
dure.
•
Switch on the ignition.
•
Without starting the engine, fully open the throttle
once or twice so that the Motronic control unit
can register the throttle-valve positions.
L
Note:
Disconnecting the battery deletes all entries (e.g.
faults, settings) stored in the Motronic control unit's
memory.
Loss of settings can temporarily impair the operat-
ing characteristics when the engine is restarted.
X
Tightening torque:
Starter motor to engine ................................ 20 Nm
Starter motor cover to gearbox housing ........7 Nm
3
1
2
S120030
12.9