Table of Contents
Advertisement
Caution: The OPC belt is extremely sensitive to bright light and direct sunlight.
Always leave it in its protective bag until you're ready to install it. Any exposure to light
should be limited to less than two minutes, or permanent damage could result. If you
suspect a belt is damaged due to exposure to light, put the belt in a dark place to
recover. Depending on the amount of exposure, recovery may take up to two hours.
Recovery time is dependent on the amount of exposure sustained, and recovery is not
guaranteed.
Also, handle the cartridge carefully. The belt is also extremely sensitive to hand oils
and scratches, both of which reduce print quality.
1
If you have an EXD model, open the
duplexer's rear cover.
Caution: Always open the duplexer's
rear cover before opening the top of the
printer. Forced opening of the printer's
top cover first may damage the unit.
If not, skip to step 2.
Advertisement
Table of Contents
