Table of Contents
Advertisement
If you still cannot identify the problem, contact your QMS vendor.
4
Is the printer printing codes or not printing at all when in ESP mode?
Reconfigure the port to the specific printer emulation of the file you are
trying to print. See chapter 4, "Printer Configuration," in the Reference
manual for instructions.
If a PostScript file prints PostScript statements while the printer is in ESP
mode, increase the ESP timeout. See chapter 4, "Printer Configuration,"
in the Reference manual for instructions.
If you continue to have problems with the ESP mode selecting the appro-
priate printer emulation, contact the QMS Customer Resource Center.
Refer to appendix A, "QMS Customer Support."
5
Is the color wrong on prints?
Check to see that you have the correct settings on the printer's Color tab.
See "Printer Drivers" in chapter 5 of this manual.
The OPC belt is extremely sensitive to bright light and direct sunlight. Always leave it
in its protective bag until you are ready to install it. Any exposure to light should be lim-
ited to less than two minutes. If you suspect the belt is damaged due to exposure to
light, put the belt in a dark place to recover. Depending on the amount of exposure,
recovery may take up to two hours. Recovery time is dependent on the amount of
exposure sustained, and recovery is not guaranteed.
If the printer has warmed up and the Data indicator stays on, two problems may exist.
If you are downloading additional typefaces, too many can overload the printer's
Advertisement
Table of Contents
