Table of Contents
Advertisement
This status message...
PUT SIZE PAPER IN
INPUTBIN BIN
PUT SIZE PAPER IN ANY BIN
REPLACE BELT
RESETTING ACCOUNTING
TEST PRINT
TONER MISINSTALLED
x TONER EMPTY
x TONER LOW
TOP COVER OPEN
TR UNIT MISINSTALLED
TRANSPORT JAM
WAITING FOR IDLE
means...
The Operator Control/Chain
Inputbins is set to Off and the
displayed cassette is empty.
Refill it with the specified size
media. SIZE is the media size
detected by the engine, and
INPUTBIN is the empty
cassette.
Operator Control/Chain
Inputbins is set to On and a
chained cassette is empty.
The OPC belt cartridge need
replacing.
The reset accounting operation
is in process.
A test print page is printing.
The toner cartridge is not
installed.
The x (color) toner cartridge is
empty.
The x (color) toner is low. There
is enough toner left to print 330
pages before the printer stops.
The top cover of the printer is
not fully closed.
The transfer unit is not installed
incorrectly.
Media has jammed while
passing through the engine.
An active job is in process.
Access to the menu is not
allowed until the job is finished.
Do this...
Refill the cassette with
the specified size media.
Refill the cassette with
the specified size media.
Install a new belt
cartridge.
No action needed.
No action needed.
Install a toner cartridge.
Replace the toner
cartridge.
Redistribute the toner in
the cartridge, or replace
the cartridge.
Ensure the top cover is
fully closed.
Check the transfer unit
installation.
Locate and remove the
jam.
Wait until the print job is
finished and the printer
goes idle.
Advertisement
Table of Contents
