Table of Contents
Advertisement
Do not allow the output tray to overfill.
»
Note: The face-down output tray has a 250-sheet capacity. Jamming may occur if
you allow media to accumulate more than 250 sheets at a time.
Store media in a dry location away from moisture and humidity.
Make sure you've loaded the media printing-side up. Many manufacturers place
an arrow on the end of the wrapper to indicate the printing side. If you can't deter-
mine which side of the media to print on, remove the media from the cassette,
rotate the stack a half-turn, turn the stack over, and then place it back in the
cassette.
Ensure that you have the correct media type selected in the driver
Select Plain Paper for standard bond plain paper.
Select Thick Stock for envelopes, glossy stock, labels, thick stock, and transfer
media.
Select Transparency for transparency media.
Ensure that you have the correct print mode selected.
»
Note: For media other than standard plain paper or transparencies, both the
driver (Paper tab, Media Type option) and the Media key on the Control Panel (for
the Print Mode) need to be selected to tell the printer that thick stock is loaded. It
is important to use the Media key to set the tray to the appropriate print mode in
order to obtain optimum printing results and to enable the toner to adhere better.
Ensure that the printer is on a hard, flat, level surface.
Ensure that the cassette only contains one type of media at a time.
Advertisement
Table of Contents
