Table of Contents
Advertisement
This status message...
FUSER OIL LOW
IDLE
INITIALIZING
INNER JAM
INPUT IDLE
PRINTING
OUTER JAM
OUTPUT BIN FULL
MISFEED JAM
PRINTING STATUS
means...
The oil bottle for the fuser unit is
running low.
The printer is on line, but no jobs
are in process.
The printer is warming up and
getting ready to go on line.
Media has jammed leaving the
OPC belt cartridge area.
The printer is on line and
printing jobs already in the
queue. No new jobs are arriving
at the communication interfaces.
Media has jammed between the
print engine and the output tray.
The media has exceeded the
limit (such as over 250 sheets of
20 lb [75 g/m²] bond) in the
output bin.
Media has jammed between the
print engine and the input
cassette.
A status page is printing
Do this...
If you have a new fuser
oil bottle on hand, you
may want to install it
now. If you don't, order
one now. A limited
number of copies (about
100) will still print.
However, when the oil
runs out, the printer
stops and the FUSER
OIL EMPTY message
appears.
No action needed.
Wait. No other action
needed.
Locate and remove the
jam.
No action needed.
Locate and remove the
jam.
Remove the media from
the output bin.
Locate and remove the
jam.
Wait until after the status
page prints, and the
message clears.
Advertisement
Table of Contents
