Table of Contents
Advertisement
4
Using a dry cotton cloth, clean the
paper exit rollers.
While manually rotating each paper exit
roller, clean each roller.
5
Close the printer's top cover.
6
If you have a duplexer, close the duplexer's rear cover.
If not, go on to step 7.
7
Plug in the printer, and turn it on.
»
Note: In compliance with UL guidelines, "The appliance inlet is considered to be
the main disconnect device."
Caution: The OPC belt is extremely sensitive to touch. Always handle the cartridge so
you don't touch the surface of the belt. Any body oil left on the surface of the belt will
prevent toner from adhering to the belt which results in poor image quality. Also, keep
the cartridge away from anything that may scratch the surface of the belt. Any
scratches will show in the image produced.
The OPC belt is also extremely sensitive to bright light and direct sunlight. Always
leave it in its protective bag until you are ready to install it. Any exposure to light should
be limited to two minutes. If you suspect the belt is damaged due to exposure to light,
put the belt in a dark place to recover. Depending on the amount of exposure,
recovery may take up to two hours. Recovery time is dependent on the amount of
exposure sustained. Recovery is not guaranteed.
Advertisement
Table of Contents
