Caution: The OPC belt is extremely sensitive to bright light and direct sunlight. Always
leave it in its protective bag until you're ready to install it. Also, handle the cartridge
carefully. The belt is also extremely sensitive to hand oils and scratches, both of which
reduce print quality.
1
Turn off the printer.
2
Open the printer's front cover.
3
If you have an EXD, open the
duplexer's rear cover.
If not, skip to step 4.
4
Pull the latch to release the top
cover, and then open the cover.
»
Note: The illustrations for steps 4–12
show the printer without the duplexer.
However, the instructions are the same
for all models.