Table of Contents
Advertisement
c
If the serial settings (baud rate, parity, data bits, and stop bits) shown on the
startup page match those in your AUTOEXEC.BAT file, you need make no
further changes. Go to the section "Changing Serial Settings" later in this
chapter.
If the printer's serial port settings are different from your PC's settings, use the
printer control panel, as described in the following section, "Changing Serial
Settings," to make them match.
Since your printer is configured at the factory for the most typical printing environ-
ments, the serial settings in your AUTOEXEC.BAT file and on the startup page
should be the same. However, if they differ, you must configure the printer to use the
serial settings specified in the AUTOEXEC.BAT file. Use the information in the follow-
ing table.
Press this key... to...
Online/Offline
Menu
Next
Select
Select
Next
Select
Next (one or
more times)
Turn off the Ready indicator and enable
printer configuration.
Access the configuration menu.
Advance to the Administration menu.
Access the Administration menu.
Access the Communications menu.
Advance to the Serial menu.
Access the Serial menu.
Advance to the Baud Rate menu.
The message window reads...
IDLE
CONFIGURATION
OPERATOR CONTROL
CONFIGURATION
ADMINISTRATION
ADMINISTRATION
COMMUNICATIONS
COMMUNICATIONS
TIMEOUTS
COMMUNICATIONS
SERIAL
SERIAL
MODE
SERIAL
BAUD RATE
Advertisement
Table of Contents
