Table of Contents
Advertisement
Default Chaining
Default Paper
Tray
Number of Paper
Trays
Page Stack Order
Left Margin
Top Margin
Resolution
This hotlink displays a screen that shows the communications settings of the printer.
Serial IF
Parallel IF
Identifies whether tray chaining is Off or On. Tray chaining
allows the printer to draw media from another input source with
either the same or any size of media (dependent on the choice
selected) automatically when the first input source empties.
Configuration Menu: Operator Control/Chain Inputbins
Tells you which input source is the default.
Configuration Menu: Operator Control/Inputbin
Tells you the number of input sources available on your printer.
Configuration Menu: No equivalent.
Tells you what order (e.g., face down) the page stack will be in.
Configuration Menu: No equivalent
Identifies the amount (in .01" increments) the image is adjusted
horizontally on the page.
Configuration Menu: Administration/Engine/Image Alignment/
Horiz Offset
Identifies the amount (in .01" increments) the image is adjusted
vertically on the page.
Configuration Menu: Administration/Engine/Image Alignment/
Vertical Offset
Identifies the printer resolution.
Configuration Menu: Administration/Engine/Def. Resolution
Identifies the settings for the serial interface.
Configuration Menu: Administration/Communications/Serial
Identifies the settings for the parallel interface.
Configuration Menu: Administration/Communications/Parallel
Advertisement
Table of Contents
