Table of Contents
Advertisement
5-4
Repair
Expansion Board Removal
Remove the sound/fax/modem board and any other installed expansion board(s) per the
following steps.
1.
Remove the system unit side panel (see "Side Panel Removal" in this section).
If you have any cables connected to the board that you need to remove, label the
2.
connectors before you remove them.
Remove the screw that secures the board to the support bracket (see Figure 5-2).
3.
Pull the board out of the connector. Gently rock the board from side-to-side to
4.
release it from its connector.
Figure 5-2 Expansion Board Removal
Advertisement
Table of Contents
Troubleshooting
