Table of Contents
Advertisement
Video Upgrade
The video board comes with 2 MB of video Window RAM (WRAM). The video board
supports an optional 2 MB video WRAM for a total of 4 MB of video WRAM. Network
configurations come with 4 MB of video WRAM and is upgradeable to 8 MB.
Install the upgrade module into the video board as follows.
Remove the system unit cover (see "Removing the Side Panel").
1.
Remove the video board installed in the PCI expansion board slot (see Expansion
2.
Board Removal).
3.
Locate the upgrade module connectors on the video board.
4.
Align the connectors on the bottom of the upgrade module with the connectors on
the video board. Press slowly and firmly until the module is seated.
Upgrade Module
Connectors
Video Module
Connectors
Figure 3-10 Aligning the Video WRAM Module with the Socket
5.
Replace the removed video board (see "Expansion Board Installation" earlier in
this section).
6.
Replace the system unit cover.
CAUTION: Before installing the video WRAM
module, reduce static discharge by touching the
system's metal chassis.
NOTE: After upgrading the video memory,
different video driver can be used to display more
colors at higher resolutions.
Option Installation
3-15
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the PowerMate Pro150 Series and is the answer not in the manual?
Questions and answers