Microphone Connection; Connecting Speaker Components - NEC PowerMate Pro150 Series Service Manual

2-6 Setup and Operation
7. Plug the other end of the cable into a properly grounded wall outlet.
Power on the speakers after the operating system has been loaded. To operate your
speakers push the power button on the front of the right speaker and adjust your volume
control.

Microphone Connection

Assemble and connect the microphone to your system unit as follows.
Snap the two halves of the microphone holder together.
1.
2. Insert the microphone holder into the slot in the microphone stand.
3. Place the microphone cable into the slot in the microphone holder.
Slide the microphone into the holder.
Plug the microphone cable into the microphone jack on the rear of the system unit
4.
(see the "Attaching the Y-Cable" figure shown earlier).
This completes setup procedures. Continue to the "Windows NT 3.51 and Driver
Installation" instructions to load the operating system.
AC Adapter
+15V DC Jack
Figure 2-7 Connecting Speaker Components
Right
Speaker