Table of Contents
Advertisement
3-18
Option Installation
Device Cables
The following optional storage devices cables are included with the system:
n
Diskette Drive Signal Cable
n
IDE Signal Cables
n
System Power Cables.
The existing diskette drive and IDE cables each support two devices. Cable connector
locations on the system board are shown in the following figure.
Diskette Drive Signal Cable
A three-connector diskette drive signal cable comes attached to the system board and to the
standard 1.44-MB diskette drive.
The installation of a second diskette drive in the system does not require the replacement of
the existing diskette drive signal cable. Connect an optional diskette drive to the middle
connector on the standard diskette drive signal cable.
NOTE: The system unit does not come with any
SCSI cables. When adding a SCSI device
(internally or externally) a SCSI cable must be
purchased for the device as well.
Diskette Drive
Connector
Figure 3-12 System Board Cable Connectors
Secondary IDE
Connector
Primary IDE
Connector
Advertisement
Table of Contents
Troubleshooting
