Expansion Board Removal - NEC PowerMate V486 Series Service Manual

5-4 Desktop Repair

Expansion Board Removal

Use the following procedure to remove an expansion board.
1. Remove the top cover as previously described.
2. Disconnect any cables leading from the expansion board.
Remove the screw from the expansion slot bracket (see Figure Section 5-3).
3.
To remove a board on the inside of the PCI/ISA-Bus backboard, remove the ex-
pansion slot screw shown in Figure Section 5-4.
Figure Section 5-4 Inside Expansion Slot Screw
Figure Section 5-3 Expansion Slot Screw