Expansion Board Removal - NEC POWERMATE VE - SERVICE MANUAL 05-1996 Service Manual

2. Remove the two cover screws shown in Figure Section 5-1.
Slide the system unit cover toward the front about one inch.
3.
Lift the system unit cover up and off (see Figure Section 5-2).
4.
Figure Section 5-2 Removing the System Unit Cover

Expansion Board Removal

Remove any installed expansion board(s) using Figure Section 5-4 through Figure Section
5-6 and the following steps.
Remove the system unit cover as previously described.
1.
Disconnect any cables leading from the expansion board(s).
2.
3. Remove the screw from the expansion slot bracket (see Figure Section 5-4).
Figure Section 5-1 System Unit Cover Screws
System Unit Repair
Screws
5-3