Mpeg Drivers Installation; Setup Utility - NEC PowerMate Pro150 Series Service Manual

MPEG Drivers Installation

After you have installed Windows NT, install the Motion Picture Expert Group (MPEG)
driver as follows.
1. Locate the NEC Utilities diskette labeled "Matrox MGA MPEG Utilities" and
insert it in drive A.
From the Windows NT desktop click on the "File."
2.
In the File Menu click on "Run."
3.
4. Type the following command line in the box.
Click on "OK" or press
5.
An introduction screen appears, click on "Continue" or press
6.
7. In the SoftPEG™ Screen, select the path for the MPEG drivers. The default path
is "C:\SOFTPEG," click on "Continue" or press
8. When the "Setup Succeeded!" message appears, click "OK" or press
This completes your Windows NT MPEG driver installation.

SETUP UTILITY

The Setup utility program allows you to enter system configuration information and control
special features of the system.
A:\SETUP
.
Enter
NOTE: Two of the icons created with the
Matrox MGA MPEG utilities diskette do not
function. The icon program names are "MPEG
File Player" and "MPEG Disk Player." When you
click on these icons, the icons give no response.
NOTE: System ships from the factory with the
correct system parameters for the configuration.
Unless adding optional hardware, run the Setup
utility only to customize the system, such as
setting the security features.
Setup and Operation
.
Enter
Enter .
Enter
2-13
.