NEC PowerMate Pro150 Series Service Manual page 45

2-8 Setup and Operation
Insert the "Setup Boot Diskette" from the Windows NT kit into drive A.
1.
2. Power on the monitor and system unit. The system performs a self test and starts
to install Windows NT from the diskette in drive A.
3. When prompted insert "Setup Disk 2" and press
The Welcome to Setup screen appears with the following message:
Press
4. Enter
The screen prompts you to select either "Express Setup" or "Custom Setup."
NEC recommends that you select "Express Setup."
5. Press Enter
6. When prompted insert "Setup Disk 3" and press
The system displays a screen listing the mass storage devices recognized on your
system.
Press
7. Enter
information will appear on the next screen.
Please select the media from which you will install
Windows NT.
NOTE: The following instructions are for a
typical system installation. For other
configurations, see your Windows NT
Workstation Installation Guide.
The setup program for the
Microsoft(R) Windows NT(TM)
operating system version 3.51
prepares Windows NT to run on your
computer.
n
To learn more about Windows NT
Setup before continuing, Press
F1.
n
To set up Windows NT now, Press
Enter.
n
To repair a damaged Windows NT
version 3.51 installation, press
R.
n
To quit setup without installing
Windows NT, press F3.
to start Windows NT Setup.
to select "Express Setup."
to continue without adding additional devices. The following
Enter .
Enter .