Replacing The Front Panel; Aligning The Front Panel - NEC PowerMate Pro150 Series Service Manual

6. Connect the device cables (see "Device Cabling").
7. Replace the system unit front panel (see "Replacing the Front Panel").
Replace the system unit cover (see "Replacing the Side Panel").
8.
Run the Setup program to set the new configuration (see Section 2).
9.

Replacing the Front Panel

Replace the front panel only after it has been removed in a 5 1/4-inch device installation.
If you are installing a 5 1/4-inch device, see "Installing the 5 1/4-Inch Device."
Route the LED and IR cables on the front panel through the chassis to the system
1.
board, and connect the cables to the board.
Insert the tabs on the right side of the front panel with the holes in the front-right
2.
side of the system unit.
3. Swing the left side of the front panel to meet the system unit. The two tabs on the
lower left side of the front panel will snap into the system frame.
NOTE: If you installed a 1.2-MB diskette drive,
remove the protective cardboard insert from the
drive.
Tabs
Figure 3-25 Aligning the Front Panel
Option Installation 3-29