5-4
Desktop Repair
Slide the top cover toward the back about one inch.
3.
4.
Lift the top cover up and off (see Figure Section 5-2).
Expansion Board Removal
Remove any installed expansion board(s) per the following steps.
1.
Remove the top cover as previously described.
2.
Disconnect any cables leading from the expansion board(s), including the multimedia
sound board audio cable (if installed).
3.
Remove the screw from the expansion slot bracket (see Figure Section 5-3).
To remove a board on the inside of the PCI/ISA-Bus backboard, remove the expan-
sion slot screw as shown in Figure Section 5-4.
Figure Section 5-2 Removing the Top Cover
NOTE: The CD-ROM uses an IDE interface sig-
nal cable. The only cable attached to the sound
board is the audio cable.