Expansion Board Removal
Remove any installed expansion board(s) as follows.
1. Remove the system unit cover as previously described.
2. Label and disconnect any cables connected to the board.
Note:
lower expansion slots, remove the AGP board from the
system (see "AGP Board Removal" later in this section).
3. Remove and save the screw securing the board to the support bracket (see
the following figure).
4. Pull the board straight out of the connector. Do not rock a PCI expansion
board from side to side to release it from the connector.
3-6 Disassembly and Reassembly
If removing an expansion board from one of the
Removing an Expansion Board