Exterior-Rear View - Ricoh CL1000N User Manual

Getting Started

Exterior-Rear View

1
1.
Parallel Port
Use a parallel cable to connect the printer
to the computer.
2.
Expansion Card Slots
Install expansion cards in these slots.
There are two slots.
3.
Power Port
Connect the power cable to this port and
the other end of the cable to the outlet.
4.
Ventilator
The ventilator helps to keep the compo-
nents inside the printer from overheat-
ing. Do not block the ventilator as it may
cause a printer malfunction due to over-
heating.
12
1
2
3
4
5
6
7
8
AAL202S
5.
Controller Board
Slide this out when installing option such
as SDRAM module (memory unit). Two
expansion card slots are included on this
board.
6.
Ethernet Port
Use a network interface cable to connect
the printer to the network.
7.
USB Port
Use a USB cable to connect the printer to
the host computer.
8.
Power Switch
Use this switch to turn the power on and
off.