Ricoh CL1000N User Manual page 82

E E E E
Press { { { { U U U U } } } } or { { { { T T T T } } } } key to specify
the length of the side that is hori-
zontal to the feed direction, and
then press { { { { # Enter} } } } key.
Note
❒ Press { { { { T T T T } } } } or { { { { U U U U } } } } key scrolls the
value in increments of 0.1 mm.
Pressing { { { { T T T T } } } } or { { { { U U U U } } } } key scrolls
the value in increments of 1 mm.
Custom Size:
Horiz.
The screen for entering the length
appears.
F F F F
Press { { { { U U U U } } } } or { { { { T T T T } } } } key to specify
the length of the side that is verti-
cal to the feed direction, and then
press { { { { # Enter} } } } key.
Note
❒ Press { { { { T T T T } } } } or { { { { U U U U } } } } key scrolls the
value in increments of 0.1 mm.
Pressing { { { { T T T T } } } } or { { { { U U U U } } } } key scrolls
the value in increments of 1 mm.
Custom Size:
Vert.
The screen returns to that of step
after a few seconds.
G G G G
Press { { { { On Line} } } } key.
"Ready" appears on the panel dis-
play.
Ready
Note
❒ To change from the "Custom
Size" setting to automatic paper
size detection, press { { { { U U U U } } } } and { { { { T T T T } } } }
C
key in step of the above proce-
dure to scroll to "Auto Detect",
and then press { { { { # Enter} } } } key.
Loading Envelopes
A A A A
B B B B
210.0 mm
C C C C
297.0 mm
D D D D
D
Pull the paper tray out slowly.
Place it on a flat surface.
Remove the paper.
Load envelopes as shown below.
Make sure there is no space be-
tween the front guide and the en-
velope. If there is a gap, pinch both
front guide ends inward (A A A A ), and
move the front guide till it is flush
against the envelope (B B B B ).
Loading Paper
2
AAL222S
AAL750S
AAL751S
27