Ricoh CL1000N User Manual page 486

WINS
Use the "wins" command to configure the WINS server settings
Reference
For more information about WINS server settings, see
The specified values of the interfaces used in each of the following settings are shown below.
interface name
ether
*1
wlan
*1
If you install the optional 802.11b interface unit, you can set the command.
Viewing setting
The following command displays the WINS server IP address.
msh> wins
Example out put:
wins: primary server 0.0.0.0
DHCP current config:
primary server 192.168.10.1 secondary server 192.168.10.2
hostname RNP620B47 ScopeID
Note
If DHCP is used to start from the network, the current WINS server address is displayed. This
address, however, is not displayed if DHCP is not used.
If the IP address obtained from DHCP differs from the WINS IP address, the DHCP address is
the valid address.
Operating Instructions
Interface to be configured
Ethernet interface
IEEE 802.11b interface
secondary server 0.0.0.0
Administrator Reference
p.311 "Configuring a WINS
261
Server".