Other Printing Problems - Ricoh CL1000N User Manual

Troubleshooting

Other Printing Problems

Toner smears appear on the
print side of the page.
5
Paper jams occur frequently.
Paper jams occur repeatedly
when using the duplex unit.
62
Status
The paper setting may not be correct. For example, although
you are using thick paper, the setting for thick paper may not
be set.
• Check the paper settings.
• Check the printer driver's paper settings.
When "
place the photo conductor unit.
See p.38 "Replacing Photo Conductor Unit Type 140".
Confirm that the paper is not curled or bent. Envelopes can
be curled easily. Flatten paper before loading.
See p.17 "Paper and Other Media".
Number of paper set in the tray exceeds the limit. Confirm
that the top of the stack is not higher than the limit mark in-
side the tray.
See p.25 "Loading Paper".
There may be a gap between the front guide and the paper,
or between the side guides and the paper in the paper tray.
Make sure there are no gaps.
See p.25 "Loading Paper".
Paper is either too thick or too thin.
See p.17 "Paper and Other Media".
Paper is bent or wrinkled. Use paper that have no bents or
wrinkles.
See p.17 "Paper and Other Media".
Paper has already been printed on.
See p.17 "Paper and Other Media".
Paper is damp. Use paper that has been stored properly.
See p.17 "Paper and Other Media".
When loading paper, separate paper from each other.
The two green screws inside the duplex unit may be loose.
Open the duplex unit's back cover and tighten them.
Possible Causes, Descriptions, and Solutions
See p.19 "Types of Paper and Other Media".
See the printer driver's Help.
Replace PCU " appears on the panel display, re-