Exterior-Rear View - Ricoh SCRIPT2 Setup Manual

Getting Started
7.
Inset Grips
Use these grips to lift the printer. There
are four grips, two on the left side and
two on the right side of the printer.
1

Exterior-Rear View

1.
Ventilator
Allows air to be discharged, preventing
components inside the printer from over-
heating. Remove this cover when replac-
ing the ozone filter.
Note
❒ Do not leave the ventilator obstructed
or blocked. Doing so creates the dan-
ger of malfunction due to overheat-
ing.
2.
Rear Cover
Open this cover when removing misfed
paper.
3.
Power Connector
Connect the power cord to this connec-
tor.
6
ZDGH040J
1
2
3
8.
Front Cover Open Lever
Press this lever to open the front cover.
9.
Top Cover Open Lever
Press this lever to open the top cover.
10.
Output Tray
Printed pages are stacked here.
4
5
6
4.
Printer Board
Remove to install optional memory unit
or network interface board.
5.
Parallel Interface Connector
Plug the parallel cable that connects the
printer to the computer into this connec-
tor.
6.
Main Power Switch
First turn on the main power switch, and
use the power switch on the front panel
to turn the printer on or off.
Normally, keep the main power switch
turned on.
Turn off the main power switch when the
printer is not to be used for a long period
of time or when moving the printer.
ZDHH020E