Ricoh CL1000N User Manual page 243

A Press { { { { U U U U } } } } or { { { { T T T T } } } } key to select "Active"
or "Not Active", and then press { { { { # En-
ter} } } } key.
TCP/IP:
*Active
After the settings are made, about two sec-
onds later, the screen returns to that of
E
step .
B Set other protocols you need to set in the
same way.
C Press { { { { Escape} } } } key.
E
The screen of step
Note
The default is "Active".
Leave unused protocols "Not Active".
Enable TCP/IP to use the Pure IP envi-
ronment of NetWare 5/5.1, NetWare
6/6.5.
Operating Instructions
appears.
Administrator Reference
F F F F
When you use this machine in DHCP envi-
ronment, proceed to step
this machine with a fixed IP address, you
must make the setting for the required item
after setting DHCP to Off. Proceed to
G
step .
Important
When DHCP is On, you cannot make set-
tings for the following items:
• IP Address
• Subnet Mask
• Gateway Address
Note
Consult your network administrator for in-
formation about making network settings.
G G G G
Set DHCP to Off.
A Press { { { { U U U U } } } } or { { { { T T T T } } } } key to display "DH-
CP", and then press { { { { # Enter} } } } key.
Network Setup:
DHCP
18
J
. When you use