Preparation Before Use; Configuring The Printer For The Network - Ricoh CL1000N User Manual

1. Preparation before Use

Configuring the Printer for the Network

When connecting this printer to a network using an Ethernet cable or an optional 802.11b interface
unit, relevant settings are required.
Configuring the Printer for the Network
Make the network settings below depending on
the network interface you use.
You can also use SmartDeviceMonitor for Ad-
min or Web Image Monitor to make IP address-
related settings in a TCP/IP-capable environ-
ment. For details about using SmartDeviceMoni-
tor for Admin, see SmartDeviceMonitor for
Admin Help. For details about using Web Image
Monitor, see Web Image Monitor Help.
Reference
For details about optional 802.11b interface
unit settings, see Option Setup Guide
Configure the printer for the network using the
printer's control panel.
The following table shows the control panel set-
tings and their default values. These items are in-
cluded in the "Host Interface" menu.
Setting Name
DHCP
*1
IP Address
Operating Instructions
Value
On
011.022.033.044
Administrator Reference
Setting Name
*1
Subnet Mask
*1
Gateway Address
Frame Type (NW)
Active Protocol
*2
Ethernet Speed
LAN Type
*1
If DHCP is in use, the IP address, subnet mask,
and gateway address are all set automatically.
*2
Make this setting only when it is necessary. See
p.198 "Host Interface Parameters"
Value
000.000.000.000
000.000.000.000
Auto
TCP/IP Active
NetWare Active
SMB Active
AppleTalk Active
Auto
Ethernet
16