Ricoh CL1000N User Manual page 633

Configuring NetBEUI for Printing
Follow these instructions to configure network interface board and Windows 2000 to use the NetBEUI
protocol.
Preparation
To use NetBEUI, use the SmartDeviceMonitor for Client port.
Configuring the printer
Enable SMB to print using NetBEUI (The default is active).
Reference
For more information about how to make the above settings, see "Configuring the printer for the
Network", Administrator Reference.
Configuring a Windows 2000 computer
Follow these steps to configure a Windows 2000 computer to use the NetBEUI protocol.
A
Click [Start] on the taskbar, point to [Settings], and then click [Network and Dial-up Connections].
B
Click [Local Area Connection].
C
On the [File] menu, click [Properties].
D
Confirm that "NetBEUI Protocol" is selected in the [Components checked are used by this con-
nection:] box on the [General] tab.
Note
If the check box of the NetBEUI protocol is not selected, select the box.
If the NetBEUI protocol is not installed, click [Install...] on the [General] tab and install it. For
more information about installing the NetBEUI protocol, see Windows 2000 Help.
Operating Instructions Client Reference
67