Ricoh CL1000N User Manual page 32

I I I I
If "802.11 Ad hoc" or "Ad hoc" is
selected for "Comm. Mode", set the
channel to use for transmission.
Note
❒ Confirm the network adminis-
trator for the channel to use.
A Press { { { { U U U U } } } } or { { { { T T T T } } } } key to display
"Channel".
IEEE 802.11b:
Channel
B Press { { { { # Enter} } } } key.
The channel currently used ap-
pears on the panel display.
Channel:
(1-11)
C Press { { { { U U U U } } } } or { { { { T T T T } } } } key to enter
the channel.
Channel:
(1-11)
D Press { { { { # Enter} } } } key.
J J J J
Set "Trans. Speed" in the same way.
Note
❒ The factory default is "Auto ". If
you need to change the trans-
mitting speed depending on en-
vironment you are using, select
the appropriate transmitting
speed.
K K K K
11
10
Installing IEEE 802.11b Interface Unit Type D
If "Infrastructure" or "802.11 Ad
hoc" is selected for "Comm.
Mode", set SSID to use for trans-
mission.
Note
❒ Confirm the network adminis-
trator for SSID to use.
❒ SSID can also be set using a web
browser. For details, see the Web
Image Monitor Help, and "Con-
figuring the Network Interface
Board Using Web Browser", Ad-
ministrator Reference.
A Press the { { { { U U U U } } } } or { { { { T T T T } } } } key to dis-
play "SSID", and then press
the { { { { # Enter} } } } key.
IEEE 802.11b:
SSID
The following message appears
on the panel display.
SSID:
Enter ID
Note
❒ The factory default is "ASSID".
❒ If an SSID has been set, you
can check the set SSID. Press
the { { { { U U U U } } } } or { { { { T T T T } } } } key to display
"View", and then press the
{ { { { # Enter} } } } key.
❒ If SSID is not set, "
" appears.
entered
1
SSID not
25