Ricoh CL1000N User Manual page 473

Community name configuration
You can set the community name of the network interface board.
msh> snmp number name community_name
Note
The community name must be within 15 characters.
Access type configuration
You can select the access type from those listed below.
msh> snmp number type access_type
Access type Type of access which is permitted
no All access is denied.
read Read only
write Read and write
trap User is notified of trap messages.
Protocol configuration
You should use the following command to set the protocols to active or inactive. If you set a protocol
to inactive, all access settings set to use that protocol are disabled.
msh> snmp {ip | ipx} {on | off}
• Specify "ip" for TCP/IP, or specify "ipx" for IPX/SPX.
• "on" means active and "off" means inactive
To change the protocol of access settings, use the following command. However, if you disabled a
protocol with the above command, making it active here will have no effect.
msh> snmp number active {ip | ipx} {on | off}
Operating Instructions Administrator Reference
248