Lexicon RV-8 User Manual page 73

SETUP
INPUT SELECT Parameter Settings
The table below describes INPUT SELECT parameter settings.
DIGITAL
• The RV-8 automatically sets the INPUT
SELECT parameter to DIGITAL when the
ANALOG IN parameter is set to NONE.
• The RV-8 sends the assigned digital
audio input connector to the Main
Zone audio output connectors. The
RV-8 ignores the assigned analog audio
input connector.
• The digital audio input connectors are
compatible with PCM (44.1kHz, 48kHz,
88.2kHz and 96kHz), Dolby Digital and
DTS(-ES) sources. If an incompatible
digital audio source (e.g., MPEG or
MP3) is present, the RV-8 automatically
selects the assigned analog audio input
connector. If ANALOG IN is set to
NONE, the RV-8 will mute.
• The DIGITAL IN parameter (page 3-7)
can be used to assign a digital audio
input connector for the selected input.
3-20
ANALOG
• The RV-8 automatically sets the INPUT
SELECT parameter to ANALOG when
the DIGITAL IN parameter is set to
NONE.
• The RV-8 sends the assigned analog
audio input connector to the Main
Zone audio output connectors. The RV-
8 ignores the assigned digital audio
input connector.
• The ANALOG IN parameter (page 3-8)
can be used to assign an analog audio
input connector for the selected input.
AUTO
• The RV-8 automatically sets the INPUT
SELECT parameter to AUTO when both
digital and analog audio input connectors
are assigned.
• The RV-8 toggles between sending the
assigned digital and analog audio input
connectors to the Main Zone audio out-
put connectors based on the input source
that is present. For example:
– When a PCM, Dolby Digital or DTS
(-ES) source is present, the RV-8 auto-
matically selects the assigned digital
audio input connector.
– The RV-8 automatically selects the
assigned analog audio input connec-
tor if no digital source is detected.
• The AUTO setting is recommended for
components that generate both digital
and analog signals, such as DVD-A/SACD
players.
Lexicon