Lexicon RV-8 User Manual page 27

RV-8
Rear-Panel Overview
(continued from page 2-8)
(with RIAA curve). A ground connector is also provided. The
phono input is optimized for moving magnet phono
cartridges.
12.Trigger Output Connectors
Provide 12V DC output to control connected components.
Two trigger output connectors are available on a removable
terminal block. The connector labeled PWR – the power trigger
output connector – is not configurable. It is activated when the
RV-8 is powered on, and deactivated when the RV-8 is turned
off from the rear-panel or by putting the RV-8 into standby. The
trigger output connector labeled 1 can be configured for
remote or program operation. See page 3-58 for more infor-
mation.
13.RS-232 Connectors
The RS-232 connector labeled 1 provides serial control. It is
capable of performing configuration downloads and flash
memory software upgrades. The RS-232 connector labeled 2 is
reserved for future developments.
14.Main Zone Audio Output Connectors
Provide analog audio output in the Main Zone. Eight connec-
tors labeled Front L/R, Center, Sub, Side L/R and Rear L/R are
available.
15.IR IN Connector
Accepts input of IR signals from infrared distribution equip-
ment. One 3.5mm jack that accepts a stereo plug (Tip/Ring
Sleeve connection) or mono plug (Tip/Sleeve connection) is
available.
16.Zone 3 Audio/Video Output Connectors
Provide analog audio/video output in Zone 3. One stereo
analog audio output (variable level) is available and can derive
its source from a variety of analog sources. One composite
video output is available and can derive its source from any
composite or S-video source.
17.Zone 2 Digital Audio Output Connectors (S/PDIF)
Provides digital audio output in Zone 2. One S/PDIF coaxial
and one S/PDIF optical (Toslink) connector is available.
18.Removable Access Panel
Reserved for future developments.
19.AC Input Connector
Provides power to the RV-8 through the supplied power cord.
20.Power Switch
Connects power to the AC input connector and disconnects
power from the AC input connector. The c c represents the "off"
position and the represents the "on" position. When the
RV-8 is powered on, the front-panel Standby button or remote
control On button can be used to activate and deactivate
standby mode. When the RV-8 is powered off, standby mode
is not available.
Basic Operation
2-9