Lexicon RV-8 User Manual page 161

RV-8
Listening Mode Menu Option & Parameter Descriptions
(continued from page 6-36)
LFE MIX
Controls the output level of LFE information – the .1 channel in a
5.1- or 6.1-channel input source – that is sent to the Main Zone
audio output labeled Subwoofer. Low frequencies from up to seven
other channels might be combined with the LFE information to
create the subwoofer output signal, which significantly increases
subwoofer output levels. Careful adjustment of this parameter
allows achievement of proper tonal balance and reduces the risk of
subwoofer overload. When the speaker setup does not include a
subwoofer, LFE information is mixed into speakers for which the
corresponding CUSTOM SETUP menu parameter is set to FULL or
to the lowest crossover points.
LISTENER POS
Refer to page 6-13.
LIVENESS
Depends on the SIZE parameter setting. The LIVENESS parameter
adjusts the amount of effect recirculation. Higher settings mimic
more reflective surfaces and increase decay time.
LOW FREQ WIDTH
Applies low-frequency spatial correction to the input signal. This
correction is applied to uncorrelated input signals below 60Hz.
-20.0dB or -10.0dB to +0.0dB
-127 to +127
30ms to 20.2s
-25dB to +25dB
MASTER LEVEL
Adjusts the output level of 2-channel LOGIC7-encoded sources.
MID RT
Works with the BASS RT and SIZE parameters to adjust the amount
of time required for mid-frequency information to decay below
60dB in level.
Setting the BASS RT, MID RT, or SIZE parameters to a high
CAUTION
value may produce undesirable or damaging audio.
OUTPUT LEVELS
MODE ADJUST (Listening Mode)
Opens the OUTPUT LEVELS menu, which can be used to adjust
output levels for the Main Zone audio output connectors labeled
Center, Sub, Side L/R and Rear L/R. The OUTPUT LEVELS option
does not appear on listening mode menus when the listening
mode does not accommodate multichannel output signals.
Instead, an output-specific parameter appears. For instance, the
Mono listening mode menu includes a SUB LEVEL parameter.
Option/ Default
Parameter Setting
CENTER +0dB
SIDE L/R +0dB
REAR L/R +0dB
SUB +0dB
MODE ADJUST
-5dB to +5dB
24ms to 24.3s
OUTPUT LEVELS
Possible
Settings
OFF, -30dB to +12dB
OFF, -30dB to +12dB
OFF, -30dB to +12dB
OFF, -30dB to +12dB
6-37