Lexicon RV-8 User Manual page 205

RV-8
Recalling the Zone Audio Codes for the RV-8
To recall the RV-8 zone audio codes:
1. Simultaneously press MAIN and ENT buttons to access SETUP
mode.
2. Press the RECAL button next to the LCD screen.
3. The LCD display will alternatively flash device names and the
three-digit code number assigned to the device for 10 seconds
and then exit to the SETUP mode. Make sure that the audio
code has the correct (default) number.
4. The MAIN zone default audio code should be 001. The ZONE
2 default audio code is 302, and the ZONE 3 default audio
code is 303. If one of these codes has inadvertently been
changed, reprogram the codes as described below.
Reprogramming the Zone Audio Codes to Default Codes
To reprogram the RV-8 zone audio codes:
1. Simultaneously press MAIN and ENT buttons to access SETUP
mode.
2. Press the P-PRO button next to the LCD screen.
3. The remote should flash SELECT BUTTON at the bottom of the
LCD screen. Press the button for the zone you wish to repro-
gram.
4. The remote should flash FROM TABLE at the bottom of the LCD
screen. Select the MAIN zone button.
5. The remote should flash ENTER NUMBER. The correct (default)
audio codes for the RV-8 zones are as follows: MAIN zone is
001, ZONE 2 is 302 and ZONE 3 is 303.
6. Enter the correct code.
C-18
7. Press SAVE on the right of the LCD screen to enter and save the
audio code for the zone.
8. Exit from Preprogrammed mode by pressing the HOME button
and then exit from the SETUP mode by pressing the HOME
button once again.
Appendix C