Lexicon RV-8 User Manual page 190

Appendix C
Note:
Programming the POWER or SYSTEM OFF buttons
with a macro overrides the preprogrammed or
learned code on the button.
See page C-10 for further information. Each of these five buttons is
designed to be able to send out a series of up to 20 commands that
are programmed into the buttons. One common use is to turn on
and turn off all A/V components with one button press. Device
buttons can be programmed with any macro sequence desired.
The remote has 10 device buttons which can send out a series of
up to 20 programmed commands when pressed for more than one
second. These buttons are commonly used in sending audio input
codes when you press the button to go to a device. The audio
receiver would make an automatic input switch according to the
device button pressed. However, these buttons can be pro-
grammed with any desired macro.
Up to 50 favorite channel buttons can be programmed into the
RV-8 remote. Each of these buttons can send out up to 10
commands. See page C-9 for Favorite Channel Programming
instructions.
Note:
The last Device selected will remain active when on
the HOME page and will be shown at the bottom of
the LCD screen. For example, if you are using "TV"
and then return to the HOME page, the hard buttons
remain in TV mode. The LCD buttons only change
when another device is selected.
The remote can be set up to operate audio component volume
control buttons (UP, DOWN and MUTE) while all the other buttons
control other equipment. The remote can also be set up to operate
channel control and transport functions (PLAY, STOP, REWIND,
FAST FORWARD, SKIP-, SKIP+, PAUSE and RECORD buttons) from
VCR, DVD, LD, CD or any other mode while all other buttons in the
remote control are controlling other components. See page C-12
for more information.
Lexicon
C-3