Lexicon RV-8 User Manual page 120

Lexicon rv-8: user guide
Hide thumbs Also See for RV-8:
Table of Contents

Advertisement

AUDIO CONTROLS
AUDIO CONTROLS
(continued from page 4-3)
MAIN MENU
AUDIO CONTROLS
MODE ADJUST
BASS
AUDIO CONTROLS
AUDIO CONTROLS
TREBLE
TUNER PRESETS
TILT EQ
TILT EQ
SETUP
LOUDNESS
BALANCE
FADER
ZONE2 BALANCE
ZONE3 BALANCE
TILT EQ
AUDIO CONTROLS
TILT EQ
Controls the amount of tilt equalization applied to the Main Zone
speaker and audio output connectors labeled Front L/R, Center and
Sub. This parameter setting affects the entire frequency spectrum
with a hinge point at 1kHz. As the setting is increased,
frequencies higher than 1kHz are boosted, while frequencies lower
than 1kHz are simultaneously cut. As the setting is decreased,
frequencies higher than 1kHz are cut, while frequencies lower than
1kHz are simultaneously boosted. The graph shown on the left of
the next page illustrates the frequency response of TILT EQ param-
eter settings.
4-4
-3.0 to +3.0dB
+0.0dB
+0.0dB
+0.0dB
+0.0dB
OFF
<|>
<|>
<|>
<|>
-3.0dB to +3.0dB
MAIN MENU
AUDIO CONTROLS
MODE ADJUST
BASS
AUDIO CONTROLS
AUDIO CONTROLS
TREBLE
TUNER PRESETS
TILT EQ
SETUP
LOUDNESS
LOUDNESS
BALANCE
FADER
ZONE2 BALANCE
ZONE3 BALANCE
LOUDNESS
AUDIO CONTROLS
LOUDNESS
Controls the amount of low-frequency boost that is automatically
applied to the Main Zone speaker and audio output connectors
labeled Front L/R, Center and Sub. When set to ON, loudness com-
pensation is automatically applied based on volume level. As vol-
ume level increases, the amount of boost automatically decreases.
The loudness contour is optimized for sources calibrated to THX
reference levels. When set to OFF, no loudness compensation is
applied. The graph shown on the right of the next page illustrates
the frequency response that is automatically applied when the
LOUDNESS parameter is set to ON and Main Zone volume level is
adjusted.
Note:
The graph on the following page shows the Loudness
parameter settings between -30dB and 0dB in one-dB
steps. The topmost line represents the curve at
-30dB.
Lexicon
ON
OFF
+0.0dB
+0.0dB
+0.0dB
OFF
OFF
<|>
<|>
<|>
<|>
ON, OFF

Advertisement

Chapters

Table of Contents
loading

Table of Contents