Lexicon RV-8 User Manual page 202

Appendix C
ing the PAGE button.
5. To edit DEVICE button text, skip Steps 3 and 4 and press the
PAGE button before selecting the Device button.
6. The character to be changed will blink. To change the charac-
ter use the number pad buttons on the remote control. The
characters assigned to each number pad button are shown
below. It will cycle to a different character each time the same
number pad button is pressed.
Note:
Move the cursor left or right using the joystick. Delete
a current character by using the cursor down on the
joystick. Using the "cursor down" technique is a quick
way to delete all of the text on a label.
1. A B C 2. D E F
5. M N O 6. P Q R
9. Y Z (Blank) 0. + - < > , etc
7. Save the text by pressing the button you were writing on (the
same function button selected in step 3 or device button in
step 4).
8. Exit from Edit mode by pressing the HOME button and then
exit from the SETUP mode by pressing the HOME button
again.
3. G H I 4. J K L
7. S T U 8. V W X
Edit Text for Favorite Channel Buttons
To edit text for favorite channel buttons:
1. Go to the SETUP mode by pressing the HOME and ENT but-
tons simultaneously for three seconds.
2. Press the EDIT button next to the LCD screen.
3. Press the FAV button and then the favorite channel button on
which you wish to write text. There are five LCD pages of
favorite channels. Select the page you wish to write on by
pressing the PAGE button.
4. The character to be changed on the button you selected will
blink and you can change the character using the number pad
buttons on the remote control. The characters assigned to
each number pad button are shown in the previous column. It
will cycle to a different character each time the same number
pad button is pressed.
5. Save the edited text by pressing the same function button
selected in step 4.
6. Exit from Edit mode by pressing the HOME button and then
exit from the SETUP mode by pressing the HOME button once
again.
Recalling the Preprogrammed Three-Digit Number
1. Go to the SETUP mode by pressing the HOME and ENT but-
tons simultaneously for three seconds.
2. Press the RECAL button next to the LCD screen.
3. The LCD display will alternately flash device names and the
three-digit code number assigned to the device for 10 seconds
and then exit to the SETUP mode.
4. Before the 10 seconds are up, pressing the HOME button on
the remote will stop the flashing and exit to the SETUP mode.
Lexicon
C-15