Lexicon RV-8 User Manual page 196

Appendix C
2. Press the LEARN button next to the LCD screen.
3. Important: Press the PAGE button.
4. Place the original remote control head-to-head with the RV-8
remote about 2 inches apart on a flat surface.
5. Select any of the 10 device buttons to program onto the RV-8
remote. Press the button on the original remote control to
program into the Device button chosen on the RV-8 remote.
Once the RV-8 remote hasreceived the signal, the RV-8 remote
will flash "GOOD" on the LCD screen, indicating it learned the
code correctly. If it flashes "FAIL," repeat from step 4 until it
learns successfully. (Make sure to enter the code signal within
20 seconds of programming.)
6. Return to step 5 until all Device buttons have been
programmed.
7. When done programming, press the HOME button to exit the
Learning mode. Exit from the SETUP mode by pressing the
HOME button once again.
Note:
Follow these instructions only if you actually want a
code sent when changing devices. It may not be
desired to send out codes when changing to a device.
For example, you program the RV-8's TV input code
on the TV device, and are currently in the DVD device
pages. The RV-8's input is set to DVD. Now you want
to quickly adjust the picture on the TV. If the TV
device button is pushed, it will change the input on
the RV-8 to TV and you will not be able to adjust the
picture for the DVD. In this case, it would be better to
not program a code to the TV device.
Programming Favorite Channels
Up to 50 Favorite Channel buttons can be programmed and
saved. Each favorite channel button can send up to 10 commands
with one button press.
To program Favorite Channel Buttons:
1. Go to the SETUP mode by pressing both the HOME and
ENT buttons simultaneously for three seconds.
2. Press the FAV button next to the LCD screen.
3. Press the device button that corresponds to the component
that the FAV channel will control. For example, pressing the TV
device will only send the type of code to which that the TV
responds to. Pressing the SAT device will only control the satel-
lite box.
4. Press the LCD button you will be assigning to the favorite
channel and enter the channel number you wish to store in the
FAV channel button. Up to 10 digits can be stored.
5. Press the favorite channel button selected in step 4 again to
store the programmed channel.
Note:
If a wrong channel number is pushed, move the cur-
sor by using the left or right button of the joystick and
then reassign the correct channel number.
6. Repeat from Step 3 until all the desired FAV channel buttons
have been programmed.
7. Once programming is completed, press the HOME button to
exit from the Favorite Channel mode. Exit from the SETUP
mode by pressing the HOME button once again.
Lexicon
C-9